WinPicProg Forums Forum Index WinPicProg Forums
A forum to support WinPicProg
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Parallel port address

 
Post new topic   Reply to topic    WinPicProg Forums Forum Index -> Suggestions
View previous topic :: View next topic  
Author Message
armo



Joined: 03 Jan 2007
Posts: 4
Location: Brasil
PostPosted: Sat Nov 24, 2007 2:01 pm    Post subject: Parallel port address Reply with quote
Hi, I m using winpicprog for a while and for a hobbyst is the easiest and fun soft. However during one of my experiments I've burned my parallel port at 0x378 address so I can not use winpicprog anymore. I bought another parallel port wich now is at 0xE000 address. Any tips on how to redirect the winpicproc to the new address?

Best regards,

Alfredo Marques
Brasil
Back to top
View user's profile Send private message
KC



Joined: 05 May 2006
Posts: 99
Location: Victoria BC Canada
PostPosted: Mon Nov 26, 2007 5:03 am    Post subject: Reply with quote
You need to configure the new parallel port to use a standard IO address. It sounds like you are using a USB --> Parallel adapter which won't work with WinPicPro because of timing issues.
_________________
KC
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    WinPicProg Forums Forum Index -> Suggestions All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group