WinPicProg Forums Forum Index WinPicProg Forums
A forum to support WinPicProg
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Changing out put values

 
Post new topic   Reply to topic    WinPicProg Forums Forum Index -> Questions
View previous topic :: View next topic  
Author Message
Manie



Joined: 12 Jun 2006
Posts: 2
PostPosted: Wed Jun 14, 2006 10:14 am    Post subject: Changing out put values Reply with quote
How do I change a single bit of a port for output? What is the syntax?
Back to top
View user's profile Send private message
Nigel Goodwin
Site Admin


Joined: 03 May 2006
Posts: 135
Location: Lower Pilsley, North Derbyshire
PostPosted: Wed Jun 14, 2006 5:32 pm    Post subject: Re: Changing out put values Reply with quote
Manie wrote:
How do I change a single bit of a port for output? What is the syntax?


There's really no point asking questions both here and on ElectroTech!, and you also didn't mention what language you're using again!.
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    WinPicProg Forums Forum Index -> Questions All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group